Banerjee, A.J. and Roy, H. and Biswal, M.K. and Lohar, A.K. and Chattopadhyay, H. and Naga Hanumaiah, Naga Hanumaiah (2017) Investigation on Tensile Behaviour of Laser Welded Al–Mg–Sc–Zr In Situ TiB2 Reinforced Metal Matrix Composite. Transactions of the Indian Institute of Metals, 70 (8). pp. 2071-2077.

Full text not available from this repository.

Abstract

The objective of the present work is to investigate the tensile behavior on laser welded Al–Mg–Sc–Zr in situ nano TiB2 composite. Al–3.5Mg–0.15Sc–0.075Zr–1TiB2 composite was melted in a resistance heating furnace. TiB2 was formed during in situ reaction of K2TiF6 and KBF4 salt mixture at 750 °C for 60 min. Welding was done using Nd:YAG pulsed laser source JK 600 (GSI make) using a robotic (IRB1410 of ABB) laser set up. The autogenous welding experiments were carried out using some of the significant parameters such as frequency—75 Hz, laser beam energy—8.10 J, pulse width—2.5 ms and welding speed—5 mm/s. It was observed that laser beam power played a major role and lower value of energy with higher repetition rate resulted better and uniform weld bead with full penetration. Five different processing methods were utilized to investigate the mechanical and metallurgical properties namely: (a) as cast (AC), (b) as cast followed by welding (AC + W), (c) as cast followed by aging (AC + A), (d) as cast followed by aging and then welding (AC + A + W) and finally (e) as cast followed by welding and then aging (AC + W + A). The ageing treatment followed was heating the samples at 300 °C for 5 h followed by air cooling. The obtained results infered that apart from the obvious superior properties shown by as cast followed by aging treatment (AC + A: 248 MPa); the AC + W + A specimens showed better properties (235 MPa) along with AC + A + W specimens (226 MPa). The fracture surface analyses revealed the following: (a) the weld region in the laser welded as cast material did not show any TiB2 in the structure probably due to the fact that temperature experienced during laser welding process might have melted the particles and was dissolved in the solid solution, (b) the interface of the weld-base region showed the presence of few TiB2 particles which lost their hexagonal shape due to preferential melting along the edges. (c) The fracture morphology of both AC + A + W and AC + W + A specimen’s showed typical mixed mode fracture with fine precipitates along the interface. The strength increased in AC + W + A at the expense of ductility due to formation of Al3Sc precipitates.

Item Type:	Article
Subjects:	Metal matrix composites
Depositing User:	Dr. Sarita Ghosh
Date Deposited:	13 Mar 2019 11:04
Last Modified:	13 Mar 2019 11:04
URI:	http://cmeri.csircentral.net/id/eprint/481

Actions (login required)

View Item